<- Home Page *Search  



Reply to topic Post new topic
14bolt narrowing questions
 
 PostPosted: Sun Jun 22, 2008 6:48 pm 

Posts: 526

Offline
does anyone have pics of how they narrowed there 14bolt, im just tryin to figure out were i should do my cut. im going to use 2 short side shafts which should bring it down to about 63wms its at 67wms right now


Top
   
 
 
 PostPosted: Sun Jun 22, 2008 7:24 pm 

Posts: 3649

Offline
I don't have pics, but I would do the following:


Take both axle shafts out of the rear end. Measure the length of the short side inner shaft, and measure the length of the long side. Take the difference in lengths, and cut the housing that difference in length from the weld center where the end flange welds to the housing. Take the short peice of housing you cut off, and grind the end flange off of the stub you cut loose. Take a flap wheel and go around the inside of the tube where you cut the rear end housing, and stick the end flange you just freed from the extra housing length you just cut off. Level the axle housing, and line up the holes for the bolt on parts (spindles, etc.) and level the end flange top to bottom. "Vee" grind the new weld joint, and weld the end back to the housing. Take a bow, you're done.


Top
   
 
Display posts from previous:  Sort by  

[ 2 posts ]
Reply to topic Post new topic


Who is online

Jump to:  

Users browsing this forum: No registered users and 1 guest



cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group